home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
Libris Britannia 4
/
science library(b).zip
/
science library(b)
/
HAM_RAD
/
3175.ZIP
/
KENWOOD3.ZIP
/
TS830.4
< prev
next >
Wrap
Text File
|
1990-09-02
|
1KB
|
25 lines
TS830.4
6. now from the remaining terminal of your new switch, connect and run
a wire to the if board to pins cw1-cw4. connect this wire to the green
wire, that is connected to one of these pins. you will then have two wires
connected to one of these terminals.
7. make sure tu have no solder shorts or bridges, make sure you have
taped or insulated any bare wire connections. mount new switch in one of
the spare holes on the baccof the radio. install the top aod bottom covers.
the modification works great, one position on the new switch and
everything isnormal, in the other position the cw filter is placed in-line
regardless of the position of the mode switch. to use the cw filters
on rtty/amtor i found i had to turn the if shift control ccw to about
the 9:30 position to center the tones in the passband. if you need an
even narrower passband, just tighten it up a little with the vbt.
good luck and good print!!!
from kf4nj - john..........RELAYED BY...N0KGX...GENE